RyeSt
Member
Registered: 13th May 04
Location: North East
User status: Offline
|
........on the crossmember. Looks like it is the clamp but cant move it anymore. The section where the clamp is looks really low. Any help will be much appreicated
|
Adam-D
Member
Registered: 11th May 02
Location: Cheshire
User status: Offline
|
undo it and spin it round
|
RyeSt
Member
Registered: 13th May 04
Location: North East
User status: Offline
|
Tried all ways just looks like it hanging lower that the standard but did everythin the same as taking it off
|
corsa_lad
Member
Registered: 8th Apr 02
Location: Bothwell, South Lanarkshire
User status: Offline
|
u might need new rubber mounts to hold it up higher
|
Greasemonkey
Member
Registered: 17th Apr 02
Location: Drives a Tractor
User status: Offline
|
if ya twist the box in an anti clockwise direction when the clamp is loose it lifts the exhaust higher at the point where it goes over the rear axle, then tighten up, this works fine on a round tail pipe as it will always look straight, if ya got an oval, twin pipe etc it might end up looking unstraight, but as said previously rotate the clamp till the nuts are at the top this will sort it, oh and get shorter focus exhaust rubbers
|
RyeSt
Member
Registered: 13th May 04
Location: North East
User status: Offline
|
Cheers for the advice greasemonkey. worked at treat!!
|
Greasemonkey
Member
Registered: 17th Apr 02
Location: Drives a Tractor
User status: Offline
|
Glad To Be Of Assistance
|
