Predator Corsa
Member
Registered: 29th Sep 03
Location: Kent
User status: Offline
|
Getting a tailgate to practive on so though ill give it a go. Cant weld it so was thinking of fibreglassing it, any1 got a guide or how i should go about doing so?
|
Aled
Member
Registered: 3rd Sep 04
Location: Westside
User status: Offline
|
Check the guide and tutorial section its all in there 
http://www.corsasport.co.uk/board/viewthread.php?tid=104260
[Edited on 06-09-2004 by Aled]
|
corsapower
Member
Registered: 9th Aug 04
Location: near bridlington
User status: Offline
|
ive just done mine, cost me £20 using my standard boot and looks good, its not that hard if you know basics about filling and smoothing
|
impacter
Member
Registered: 9th Mar 04
Location: Bristol
User status: Offline
|
don't you need to do some welding?
|
corsapower
Member
Registered: 9th Aug 04
Location: near bridlington
User status: Offline
|
i did i welded a plate in but you can do it with fibreglass
|
corsa andy
Member
Registered: 18th Aug 04
Location: torpoint
User status: Offline
|
u can get a pannel from wwwcorsacentre.com for 45 pound i think maybe that maybe an option
|
dragoncorsa
Member
Registered: 2nd May 02
Location: manchester, GSImerit??????
User status: Offline
|
the welding needs to b done otherwise its not safe and the whole job just could fall out my mates did that, and iv just finishing off mine its fun mate get goin on it ull really enjoy yourself oh and panels r s.h.i.t.e.e.e.e.e.e
|
wezjax
Member
Registered: 28th Mar 02
Location: mansfield,notts
User status: Offline
|
if your going to attempt it then you may aswell do it properly and learn to weld at the same time.
|
Predator Corsa
Member
Registered: 29th Sep 03
Location: Kent
User status: Offline
|
quote:
Originally posted by wezjax
if your going to attempt it then you may aswell do it properly and learn to weld at the same time.
then i will need a welder and welding rods, and metal plates  what metal would you use and where would u get it from?
|
wezjax
Member
Registered: 28th Mar 02
Location: mansfield,notts
User status: Offline
|
you don't need rods, just use a mig welder.
mild steel plate around 1.6mm. most steel works chuck pieces the size of what you need away so ask around.
|
