Coblet
Member
Registered: 26th Jun 04
Location: Camberley, Surrey
User status: Offline
|
So my Oz Titans are 16", but they have an offset of ET37 - how the hell am I meant to lower without scrubbing... or will I be safe? I was thinking of a 45mm drop, but I haven't really seen any pictures of guys who've dropped on 16"s in garages, everyone seems to have 17s/15s
Advice? Especially interested in which suspension route you think is the best to go... budget coilovers or what?
|
ed
Member
Registered: 10th Sep 03
User status: Offline
|
They will scrub even if you don't lower the car. You will probably fail your MOT too because they will poke out the wheels arches too much.
|
Coblet
Member
Registered: 26th Jun 04
Location: Camberley, Surrey
User status: Offline
|
They don't stick out THAT badly... can I not get spacers to help the problem?
|
sigibbons
Member
Registered: 10th Feb 04
User status: Offline
|
Hmmmm why are spacers called spacers??
Because they space the wheels OUT that will make it worse!
|
Coblet
Member
Registered: 26th Jun 04
Location: Camberley, Surrey
User status: Offline
|
Ok that was bad advice given to me by someone else, lets forget the spacer idea.
|
ed
Member
Registered: 10th Sep 03
User status: Offline
|
Well, they will stick out a fair bit, seing as they are 11mm out too far and they will be about 7" wide. Unless your gonna fit PSG arches don't even try.
|
Coblet
Member
Registered: 26th Jun 04
Location: Camberley, Surrey
User status: Offline
|
Time to look for some PSG arches then. These aren't as much as 7" wide, I think they are about 6.5"
|
ed
Member
Registered: 10th Sep 03
User status: Offline
|
A right, you could go to R-Tec and see if they can roll your rear arches back or cut some material off the arch to get them wheels on before you go the wide arch route...
|
sigibbons
Member
Registered: 10th Feb 04
User status: Offline
|
http://www.corsasport.co.uk/board/viewthread.php?tid=136850&page=1
|