russb
Member
Registered: 30th Oct 04
Location: chester-ish
User status: Offline
|
My Fault codes!!!
12-Initiation of diagnosis.
85-Immobiliser Wrong signal
43-Primary ignition (distributor systems) High voltage
84-Immobiliser No signal
56-Air control soleniod Low voltage
63-63 Amplifier control signal, cylinders 2 and 3 (Direct Ignition System (DIS)) Low voltage
64-64 Amplifier control signal, cylinders 1 and 4 (Direct Ignition System (DIS)) Low voltage
29-Fuel pump relay Low voltage
92-Camshaft sensor Faulty hall effect sensor or circuit
93-Quad drive module (in ECU)
35-Idle stepper motor Poor or no idle speed control
19-Crank Angle Sensor (CAS) Incorrect RPM signal
34-Manifold Absolute Pressure (MAP) sensor Low voltage
15- Coolant Temperature Sensor (CTS) High voltage
now is it me or is it very unlikly that they have all broke? considering i have bought BRAND NEW sensors - CTS,CAS,CSS, i think i need to get an ECU
|
James R
Member
Registered: 4th Feb 03
Location: 205GTi16/306GTi16
User status: Offline
|
Take it to a local ECU test centre andget them to run a diag on it's £40, could also be the loom though mind.
|
corb
Member
Registered: 24th Apr 02
Location: Calgary, Alberta, Canada
User status: Offline
|
have you re-set your ECU?? If its buggered, it normally knows it and has a fault code for a fucked ECU, as I had this . Disconnect you battery for an hour or so, should reset the ECU.
|
russb
Member
Registered: 30th Oct 04
Location: chester-ish
User status: Offline
|
the battery has been disconnected for 3 days
|
russb
Member
Registered: 30th Oct 04
Location: chester-ish
User status: Offline
|
but even before it was disconnected, i did get alot of random fault codes, thats why i have loads of new sensors, i gave up after a while coz the codes where staying there!!
|
russb
Member
Registered: 30th Oct 04
Location: chester-ish
User status: Offline
|
what could be up with the loom?
|
corb
Member
Registered: 24th Apr 02
Location: Calgary, Alberta, Canada
User status: Offline
|
You're not getting damp onto the ECU are you? mine did this, was running down the loom into the footwell. Kept chucking all sorts of fault codes at me.
|
calidus
Member
Registered: 27th Oct 02
Location: Lincoln
User status: Offline
|
yer i had the dampness problem, take ecu out n check the pins?
|
Kerry
Member
Registered: 5th Oct 01
Location: Norwich
User status: Offline
|
i had a similar problem and it turned out all the connections in my fuse box had gone green as the car was once stood a long time. cleaned all the connections up and it was fine after that
|