Welsh Dan
Member
Registered: 23rd Mar 00
User status: Offline
|
As above - Used, but supplied with original box and bits.
KX600.1
Kicker KX600.1 monoblock amp. Rated at 700w, its certainly got plenty of muscle.
Boxed with instructions, and complete with remote bass adjusting thingy. 'However', the cable is missing for the remote bass controller, although its only a standard modem type lead which can be picked up for a few pence. The amp can still be used absolutely fine though without it. Few marks on the chassis of it too, but you could paint them out if you wanted. Only selling it as I have no need for it without a sub and I won't put it in my new car.
RMS Power (WATTS), MONO: 600W @ 2 Ohm
Remote Bass Control: Yes
Fan Cooling: Yes
Length With Shroud (IN.): 22-1/2
Width With Shroud (IN.): 10
Height With Shroud (IN.): 2-1/2
Frequency Response: 20Hz-200Hz; +0, -1dB
Input Sensitivity: High Level 340mV-10V, Low Level 170mV-5V
Signal-to-Noise Ratio: >95dB, a-weighted, re:rated power
Active Crossover: 12dB/Octave, variable 50Hz-200Hz, low pass only
KICKBass Boost: Variable to +18dB, centered @ 40Hz
12dB Subsonic Filter Defeatable @ 25Hz
The amp is £299 ish new, but given that its not been used much in the RX, and has been sat under the stairs for months, £180 ONO
KX200.2
The removeable part of the amplifier has a few scratches, but the amplifier works absolutely fine. Selling, as I have no further need for it. £75 or make me an offer.
Spec is as follows
100W x 2 @ 2 Ohms RMS
50W x 2 @ 4 Ohms RMS
200W x 1 @ 4 Ohms RMS mono bridged
Frequency Response: 20Hz-20kHz; +0, -1dB
Input Sensitivity: High Level 340mV-10V, Low Level 170mV-5V
Signal-to-Noise Ratio: >95dB, a-weighted, re:rated power
Active Crossover: 12dB/Octave, variable 50Hz-200Hz, selectable high pass, low pass, or all pass
KICKEQ Bass Boost: Variable to +18dB, centered @ 40Hz Pass-Thru RCAs
8 gauge Power Wire input. 40 Amp fuse rating
Protection built-in
Dimensions : 2.50 X 10.00 X 16.00 (inches)
Add to the "Buy Dan an S2k fund" today!
|
