v5uk
Member
Registered: 20th Nov 02
Location: Wigan Lancashire
User status: Offline
|
Can you use Calibra equal length shafts on a Corsa (obviously with bigger hubs) but are they the same length, also while im at it – Corsa diesel shafts are they 22 spline?? Or is someone ripping the p!£$ out me
cheers Steve
|
ckallis500
Member
Registered: 14th Dec 04
Location: plymouth
User status: Offline
|
right i have never seen diesel shafts which are 22 spline, best bet is to use the calibra equal length shafts and cv's, all you need then is the modified hubs which u can buy on ebay for £55quid....
|
Lisa
Member
Registered: 6th Apr 00
Location: Euxton, Lancashire
User status: Offline
|
ive got an astra shaft on one side and a calibra shaft on the other side , seems to work ok . the calibra one is the long one.
laurence
|
v5uk
Member
Registered: 20th Nov 02
Location: Wigan Lancashire
User status: Offline
|
Laurence / Lisa the Astra N/S shaft did you have to fuc about with it or was it a straight fit – just using bigger hubs.
Last conversion I did, (using Calibra shafts) I noticed that the O/S fitted fine but the N/S was slightly too long, other people have said to trim the N/S shaft and make a new ring for the CV cur-clip to fit into, but all sounds a bit dodgy too me.
GSI shafts seam to be a nightmare to get hold of these days.
[Edited on 06-10-2006 by v5uk]
|
v5uk
Member
Registered: 20th Nov 02
Location: Wigan Lancashire
User status: Offline
|
Been offered loads of 22 spline shafts but looks like people are counting the out side splines and not the inside spline’s
you need to split the CV off to count the splines
like the pics above.
normal shafts have a inside spline of 28 I'm looking for 22 spline ones
|