Jules
Member
Registered: 26th Nov 04
Location: Ipswich, Suffolk Status: Happy
User status: Offline
|
Was working fine a couple of days ago - now it doesn't move, engine is still getting warm as normal as heaters are working ok.
No ECU light so guessing it's not the sensor (unless that doesn't trigger the EML?), any idea where the Coolent Temp sensors are located on a C16XE lump?
Also I seem to have a small water leak coming from somewhere near the drivers side of the rad as there is a small stream of steam coming from there occasionally - could this be related to the temp gauge issue?
|
Vaux Lad
Member
Registered: 15th Dec 04
Location: Stoke-on-Trent
User status: Offline
|
The ecu coolant temp sender is a different one than what supplies the dash.
The one for the dash is the smaller one, on the thermostat housing with a spade terminal.
|
mattievRS
Member
Registered: 20th May 06
Location: Leicester
User status: Offline
|
check the spade connector on the side of the stat house.
|
Corsa E-Tec
Member
Registered: 4th Feb 04
Location: Stevenage Drives: Leon Cupra
User status: Offline
|
check temp sensor is connected.
sensor wire is a spade connector underneath the big connector
wire shown in pic
[Edited on 09-04-2007 by Corsa E-Tec]
|
Jules
Member
Registered: 26th Nov 04
Location: Ipswich, Suffolk Status: Happy
User status: Offline
|
Thanks guys, will go ch ch ch check it out now and report back 
EDIT: Yep the little spade connector on the smaller sensor had come off, I got a pair of pliers and squashed the spade a bit and put it back on nice and tight so it shouldn't come off anymore 
Cheers people
[Edited on 10-04-2007 by Jules]
|
Corsa E-Tec
Member
Registered: 4th Feb 04
Location: Stevenage Drives: Leon Cupra
User status: Offline
|
sweet as.
|
