rick xe
Member
Registered: 25th Apr 07
Location: west midlands
User status: Offline
|
has anyone had problems fitting big block cv"s into chris astley hubs?Ive wrecked two wheel bearing trying to pull cv"s in
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
we sell the same hubs as chris, never had a problem with them.
sure you are using the right cv joints?
|
rick xe
Member
Registered: 25th Apr 07
Location: west midlands
User status: Offline
|
1992 calibra outer cv"s ive tryed vauxhall and local motor factor ones none fit.
|
rick xe
Member
Registered: 25th Apr 07
Location: west midlands
User status: Offline
|
anyone??????any ideas
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
should slot straight in, what driveshafts are you using? why are they damaging wheel bearings? tight fit?
|
rick xe
Member
Registered: 25th Apr 07
Location: west midlands
User status: Offline
|
yes tight fit,as the teeth end on cv there is a raised flat section about half inch long witch matches the inner hub at rear,this is the part what seams to be catching on inner hub.shafts are calibra equal length ive used them before on other convertions.
|