oceansoul
Member
Registered: 19th Jun 06
Location: Sunbury, Surrey
User status: Offline
|
im trying to remove my cam cover(rocker cover) to replace the gasket.
I guess i have to remove the top half of the inlet mainfold to gain access.
Ive removed all the the bolts securing the top manifold, but its still attached to the throttle body, and i cant see any way of seperating it ?? any ideads how to remove it??
Also does the cam belt plastic cover thingy need to be romeved?
Its an x14xe btw 1998
[Edited on 25-01-2008 by oceansoul]
[Edited on 25-01-2008 by oceansoul]
|
Richardhhha
Member
Registered: 29th Sep 07
Location: Croydon, Greater London
User status: Offline
|
cam belt cover just needs to be teased over to one side when removing cam cover, you sure you have removed all the bolts, hmmm the throttle body is on the lower manifold your going to need a pair of plyers and take the clip off that holds the rubber hose between upper and lower. Its really easy job takes you about 20 minuits from start to finnish so not bad
|
oceansoul
Member
Registered: 19th Jun 06
Location: Sunbury, Surrey
User status: Offline
|
cheers for the reply, ok ill try to remove the clips on the rubber large rubber hose.
i think all the bolts are removed as it lifts up just a little but is restriced by the rubber hose connecting it to the throttle body
|
