swill_omnibus
Member
Registered: 12th Dec 07
Location: : S. wales Drives: Dodge Caliber
User status: Offline
|
Hi all,
Well ive never had a problem of anysort with this car up until now, and god do i know how to have a prob! lol
Anyway.
yesterday i installed my angel eyes, all perfect nowt wrong.
Today, i put new rear lights in and found out that one of the indicators didn't work, but i also found that a fuse had blown (bottom 2nd left) is a red 10 fuse. "KL" according to the legend.
So now, when ignition is on, no light are coming on, when engine is started the battery light is on, theres no petrol gauge reading, no mph reading or water temp reading, theres no de-misting for the wing mirrors, when i indicate left it ticks really fast, when i apply the hand brake the rev drops to zero then goes back up2 normal idle.
So basically, iv'e really fudged things
Any light to be shined here?
|
supermike
Member
Registered: 6th Sep 05
Location: Aberdeen. Drives: 1.4 16v Corsa
User status: Offline
|
Oh dear seams like you are having problems, sounds to me like you have shorted out somehting while installing the lights, check all the fuses etc. Battery light being on while the car is started means the battery is not getting charged. First things first check your fuses replace any blown ones and then check all your wires for headlights etc
|
swill_omnibus
Member
Registered: 12th Dec 07
Location: : S. wales Drives: Dodge Caliber
User status: Offline
|
All the fuses checked and all seem fine, except for one which was replaced. Was a 10amp but only had a 7.5 handy. That should be ok shouldn't it as it isn't exceeding 10 yes/
I'll check all wiring again just incase it's fouling anywhere.
Cheers so far m8!
|
supermike
Member
Registered: 6th Sep 05
Location: Aberdeen. Drives: 1.4 16v Corsa
User status: Offline
|
being only 7.5 might have blown again. Your better with a 10 but never go above 10 because then you run the risk of burning out wiring.
|
swill_omnibus
Member
Registered: 12th Dec 07
Location: : S. wales Drives: Dodge Caliber
User status: Offline
|
Checked all fuses again but didn't get to a car spares in time to get a fuse so that'll be done tomoz now.
Checked all wiring and there doesn't seem to be anything that would foul anywhere or there isnt nowt burnt or anything.
When i went to take the interior dash bulbs out though, there was smoke coming from the bronze strip that lies there. I personally think that has shorted something somewhere!
|
swill_omnibus
Member
Registered: 12th Dec 07
Location: : S. wales Drives: Dodge Caliber
User status: Offline
|
Just checked all fuses in drivers compartment all seem fine and also fuse box in engine bay, the lonely thing seemed fine also.
Bump also too
|
supermike
Member
Registered: 6th Sep 05
Location: Aberdeen. Drives: 1.4 16v Corsa
User status: Offline
|
hmmmm weird, could be a manufacturing problem with the lights, have you tired fitting the standard lights to see if the problem persists with the standard items
|
swill_omnibus
Member
Registered: 12th Dec 07
Location: : S. wales Drives: Dodge Caliber
User status: Offline
|
Well the lights ive put on look the same as original but just clear so the bulb holder looks exactly the same!
I think when i tried taking the bulb from the centre console out, i was told with a screwdriver to release the little clip and pull it out.
When i tried that, smoke did come from that......... So i think it must be something to do with that personally!
|
pow
Premium Member
Registered: 11th Sep 06
Location: Hazlemere, Buckinghamshire
User status: Offline
|
Try pulling the fuse for interior lighting and trying again
|
swill_omnibus
Member
Registered: 12th Dec 07
Location: : S. wales Drives: Dodge Caliber
User status: Offline
|
Ah-ha all sorted. Got my dads mate to come round and poke a few bits while i was in work.
Said sumin bout a few wires behind the box had burnt i think.
Cheers for everyones help , much appreciated
|