harrisp
Member
Registered: 15th Dec 07
Location: Derbyshire
User status: Offline
|
How hard is it?
How is it done?
Thanks,
|
corsa-jr
Member
Registered: 2nd Feb 09
Location: Essex
User status: Offline
|
think its a matter of welding the seat to the frame, i don't think that they bolt up proply
|
harrisp
Member
Registered: 15th Dec 07
Location: Derbyshire
User status: Offline
|
So I cant just make up some brackets and bolt them together?
|
corsa-jr
Member
Registered: 2nd Feb 09
Location: Essex
User status: Offline
|
you could make custom brakets yer but if you wanted to use the corsa sub frame i think its a welding job
|
Terry12
Member
Registered: 24th Sep 07
Location: Manchester
User status: Offline
|
The way I've done mine is weld tabs of metal to the Corsa runner as the Vectra frame holes are wider apart than the Corsa seat mounting points.
Then I drilled the tabs to align the Vectra frame holes.
My frame are Cobreau ones though. So on the original Corsa frame you'd have to cut the seat mount points off as they vertical and not horizontal then weld your tabs to the flat part.
The base is very tight to the door.
|
alan-g-w
Member
Registered: 9th Nov 07
Location: Glasgow
User status: Offline
|
That's a very nice interior mate. You should get the rears trimmed to match.
[Edited on 12-05-2009 by alan-g-w]
|
Terry12
Member
Registered: 24th Sep 07
Location: Manchester
User status: Offline
|
That's the plan mate, However the material is about £70 per metre so i'm told
|