Sean
Member
Registered: 14th Sep 10
Location: Eastbourne, BN23 7AZ
User status: Offline
|
is this the way they go up i have some of these and they only seem to fit when i have the writing upside down (the way they are in the picture) and do i have to have the black adjuster bit on when i put them on?? if that makes sence haha
had this post in mod help no1 was answering so put here 
|
corsa-crazy
Member
Registered: 15th Jan 11
User status: Offline
|
they way they are in the picture is correct but turn them upside down and thats the way they go in.
[Edited on 15-01-2011 by corsa-crazy]
|
Sean
Member
Registered: 14th Sep 10
Location: Eastbourne, BN23 7AZ
User status: Offline
|
so with the adjuster bit at the bottom?
|
Sean
Member
Registered: 14th Sep 10
Location: Eastbourne, BN23 7AZ
User status: Offline
|
and do i even need the adjuster bit in?
|
kennySRi
Member
Registered: 12th Nov 10
Location: Lancashire
User status: Offline
|
No you dont need them in.
|
Sean
Member
Registered: 14th Sep 10
Location: Eastbourne, BN23 7AZ
User status: Offline
|
when i tried them in i wasnt sure which way they went in so i had them with the text upside down end with the smaller hole they fit in ok that way the way they are in pic is this right? didnt really understand corsa crazies post
|
corsa-crazy
Member
Registered: 15th Jan 11
User status: Offline
|
the way they are in the picutre,but just turn the whole lot upside down and fit this way,adjusters to the bottom,make sure the flat bit of the spring on the bottom is resting on the adjusters and the top of the spring make sure the end of the curve is pointing to the front of the car,
should look nice hopefully !!
|
wrighty_1989
Member
Registered: 7th Jan 07
Location: Nottinghamshire
User status: Offline
|
Ye the adjuster is supposed to be at the bottom, and you may have to remove a ring type thing from the rear beam where the adjuster sits so it goes on correctly.
|
