KyleCorsa
Member
Registered: 6th Jan 09
Location: Wrexham (North Wales)
User status: Offline
|
hi have put a c20xe redtop in my corsa we have spark and fuel and it wont fire up. If u take the plugs out they are dripping in petrol. I have cleaned the fuel off and tried again and the same keeps happening. Any ideas what is going on, thanks.
|
craig55
Member
Registered: 12th Jun 10
Location: Bristol
User status: Offline
|
Make sure all earths are connected
|
Darryl H
Organiser: South Central
Premium Member
Registered: 19th Nov 09
Location: Camberley Drives: Porsche 944
User status: Offline
|
quote:
Originally posted by craig55
Make sure all earths are connected
This and does it have a lambda?
|My Corsa|SC|My Instagram|
|
KyleCorsa
Member
Registered: 6th Jan 09
Location: Wrexham (North Wales)
User status: Offline
|
Yes mate it does have a lambda. How many earths should there be?
|
Darryl H
Organiser: South Central
Premium Member
Registered: 19th Nov 09
Location: Camberley Drives: Porsche 944
User status: Offline
|
Can't remember mate, sorry.
Is the engine management light (EML) wired in?
And have you got any fault codes through it?
|My Corsa|SC|My Instagram|
|
KyleCorsa
Member
Registered: 6th Jan 09
Location: Wrexham (North Wales)
User status: Offline
|
Yes mate its wired in. No havn't checked that yet. It started up for a few seconds earlier and then cut out again and wouldnt start again
|
Generation
Member
Registered: 7th Jul 09
Location: Essex
User status: Offline
|
Mine are different as relocated.
Should be around 4.
|
KyleCorsa
Member
Registered: 6th Jan 09
Location: Wrexham (North Wales)
User status: Offline
|
Around 4? Ok thanks mate. Where abouts? Got one from battery to bulkhead, 1 or maybe 2 from by fuel rail to bulkhead. Should there be an earth on the box? And would that cause it not to start though?
|
Darryl H
Organiser: South Central
Premium Member
Registered: 19th Nov 09
Location: Camberley Drives: Porsche 944
User status: Offline
|
needs one to go to either engine or gearbox yeah
|My Corsa|SC|My Instagram|
|
craig55
Member
Registered: 12th Jun 10
Location: Bristol
User status: Offline
|
One to the bulkhehed from battery
Three on the fuel rail
One from the alternator to a earth
One from chassis to either box or engine
|
Ian
Site Administrator
Registered: 28th Aug 99
Location: Liverpool
User status: Offline
|
Check nothing came loose when it ran, plugs, earths, bits of loom etc.
How did it cut out? Are all plugs the same? Was it a known runner when you got it?
|
KyleCorsa
Member
Registered: 6th Jan 09
Location: Wrexham (North Wales)
User status: Offline
|
Yes seen it running in the car before it was removed. Its not seen the road yet, fired up for a few seconds last night then cut out and wouldn't start again. Ill check all them earths again later on then and make sure I have them all on. Thanks 
|
reecegsi
Member
Registered: 16th Mar 11
Location: birmingham
User status: Offline
|
Make sure leads are correct order and fuel pump relay clicks? Ecu power up?
|
Stoneyginger
Premium Member
Registered: 25th Jan 01
Location: Stonehaven, Aberdeenshire
User status: Offline
|
I have earth from alternator to engine, earth from negative battery to bulk head and earth from chassis leg to engine head
|
Vauxdan88
Member
Registered: 13th Feb 11
Location: Weymouth Dorset
User status: Offline
|
off the top of my head isnt there one going from starter to back of block too?
|
john_redtop
Member
Registered: 31st Dec 08
Location: acklam middlesbrough
User status: Offline
|
Try a new coolant temperature sensor after my conversion car fired up ran for about 10 seconds cut out then wouldn't start again as sensor was knackered and feeding the engine too much fuel
|
Spencer627
Member
Registered: 1st May 12
Location: Essex
User status: Offline
|
ine did this, turned out to be a loose wire in the coil pack plug, check things like that
|
