Mr Turner
Member
Registered: 20th Oct 07
User status: Offline
|
hi, i was out in the car last night and it started to sound realy loud and rough at like 2000 rpm and was picking up realy slowly even when i had my foot down, it seemed realy flat and the sound was a realy deep roar, bit like an induction kit kindy of noise, after about 5 minutes it was fine and went perect, i then stoped the car and come back to it, drove it for about 10 minutes and had the same problem but only for about a minute then it didnt do it again, anybody got any ideas what it could be?
thanks for any help
|
Warren G
Member
Registered: 14th May 06
Location: Kent
User status: Offline
|
big air leak?
blocked exhaust?
|
gez bay
Member
Registered: 14th Feb 08
Location: South Wales drives: Vxr
User status: Offline
|
check the rubber around the throttle bodie might have come loose, happened to my friends corsa, went really loud and idled at 3000rpm
|
Mr Turner
Member
Registered: 20th Oct 07
User status: Offline
|
have checked them just now and all seem ok to me, any other suggestions? could it be the air flow meter? i heard some where that different induction kits cause the airflow meter to fuck up? would this cause it to do what mine was?
|
Warren G
Member
Registered: 14th May 06
Location: Kent
User status: Offline
|
what engine?
|
byrnie_2004
Member
Registered: 11th Mar 07
Location: Marple, Greater Manchester
User status: Offline
|
my mates did this for ages, it only got worse over time, his centre silencer on his exhast had collapsed.
|
Mr Turner
Member
Registered: 20th Oct 07
User status: Offline
|
its a 1.4 16v sport
|
Alan-16V
Member
Registered: 5th Apr 08
Location: North Wales
User status: Offline
|
id start with checking the simple things first like all the vacume pipes are in good condission and not split, also check the plugs and leads and double check all the sensors are all pluged in properly.
|
mattievRS
Member
Registered: 20th May 06
Location: Leicester
User status: Offline
|
put money on it being the crank pulley slipped on the crank shaft keyway mate(basically giving the engine the wrong signals for fuelling and spark).its at the bottom of the engine on the drivers side.you can see it from inside the wheel well.but youll need to take the alterator belt off and then use a e16 torx socket(i think) to get it off to check it for damage.think theyre about 60 quid from vaux though.
btw x14xe wont have an air flow meter
[Edited on 05-04-2008 by m17tty]
|
Mr Turner
Member
Registered: 20th Oct 07
User status: Offline
|
ok mate cheers for that, so if it is what you say i am lickely to see this get worse? and also what should i look for when its off?
|
Mr Turner
Member
Registered: 20th Oct 07
User status: Offline
|
cheers alan-16v will do that
[Edited on 05-04-2008 by Mr Turner]
|
Rob E
Member
Registered: 1st Jan 06
Location: Madeley, Stafford....I want to live back in Wales!
User status: Offline
|
could also be a sticky egr valve....did an engine light come on the dash? If so get it to somewhere with equipment to read off the code
|
Chiggs1989
Member
Registered: 7th Aug 06
Location: Dover, Kent
User status: Offline
|
sounds like egr valve
|
mattievRS
Member
Registered: 20th May 06
Location: Leicester
User status: Offline
|
quote: Originally posted by Mr Turner
ok mate cheers for that, so if it is what you say i am lickely to see this get worse? and also what should i look for when its off?
yeah it will get worse slowly mate.when the crank pulley is off you will see if its fucked,trust me
|
Mr Turner
Member
Registered: 20th Oct 07
User status: Offline
|
no no engine light came on, the dash was as normal, car was perfect apart from it pulling like a bag of shit, ok m17tty cheers for the advice.
[Edited on 06-04-2008 by Mr Turner]
|