gordo
Member
Registered: 23rd Aug 08
Location: drongan
User status: Offline
|
hi folks, can you guys tell me if the timing on the x16xe is set to the same as on a gsi? as the workshop manual i have doesnt cover my engine. just i have it set for the gsi spec but sounds like it out. then i rev it it wants to die and give the odd pop. also it is smoking badly. not sure if its cause the head has just been put on it and it hasnt run in months. before i fitted the head i had it pressure tested and skimmed so the head is fine and was hardly any play in the pistons. any suggestions.
thanks guy.
|
gordo
Member
Registered: 23rd Aug 08
Location: drongan
User status: Offline
|
cant anyone help me out?
|
barneykarl
Member
Registered: 29th Jul 06
Location: Stevenage
User status: Offline
|
I would say tdc is tdc on any engine , i should imagine the gsi would be the same as a x16xe, not had to do mine but sure there are peeps on here who know this sort of stuff. 
|
jonakamad
Member
Registered: 27th Jan 09
Location: Swindon
User status: Offline
|
sounds like the valve stem oil seals mite be going if its smokin
|
john_c20xe
Member
Registered: 10th Feb 08
Location: Eastbourne, EastSussex
User status: Offline
|
play in the pistons? what u mean?
valve stem oil seals only smoke on start up and when u boot it after rolling down a steep hill,
it it smokes when u giv it some then it will be piston rings no dout.
and on a gsi? what engine in the gsi? as i have a gsi with a x16xe! the timing marks are the same as c16xe.
the cams should have small notches in them and should be facing each other!
there will be a mark on the crank witch corrasponds to the plastic cover
|
