D14LY
Member
Registered: 7th Jan 08
Location: North east
User status: Offline
|
how to get rid of an airlock out of cooling system?? i've changed the thermostat but temperature keeps going right up and sumtimes wen heaters are on hot cold air is blowin through, dont no wats causin this, any ideas?? please
|
Slammed_Corsa
Member
Registered: 30th Oct 05
Location: Greenock, Inverclyde
User status: Offline
|
Let the car heat up with the cap off the expansion tank. Let it cool down then put it back on.
|
D14LY
Member
Registered: 7th Jan 08
Location: North east
User status: Offline
|
cheers m8 i'll hav a go
|
D14LY
Member
Registered: 7th Jan 08
Location: North east
User status: Offline
|
nothing happened m8 stil the same, water level never moved..
|
Sean-B
Member
Registered: 1st May 07
Location: Wolverhampton Drives: 200SX S14a
User status: Offline
|
is it leaking?
is there creamy crap under your oil cap?
is it full?
has it got any antifreeze in it?
|
D14LY
Member
Registered: 7th Jan 08
Location: North east
User status: Offline
|
no its not leaking, no creamy stuf on oil cap, yes its jst above the line but no antifreeze in..
|
D14LY
Member
Registered: 7th Jan 08
Location: North east
User status: Offline
|
any other sugestions ppl thanks
|
barneykarl
Member
Registered: 29th Jul 06
Location: Stevenage
User status: Offline
|
What was the reason for the new stat did you have problems before you fitted new stat?, squeeze all the main hoses with the cap off to try and expell trapped air, do you get coolant coming into the expansion bottle? are you sure your w/pump is ok .leave heater open cap off and run engine and squeeze hoses.
|
DaveyLC
Member
Registered: 8th Oct 08
Location: Berkshire
User status: Offline
|
As Karl says you need to squeeze all the hoses to try and 'dislodge' any air locks, it could also be a failed water pump
|
D14LY
Member
Registered: 7th Jan 08
Location: North east
User status: Offline
|
changed stat because i thought it might not have been working and when lid is off expansion bottle and i squeeze pipe u have to squeeze really hard before it bubbles up
|
Gareth F
Member
Registered: 16th Jan 08
Location: Location Location
User status: Offline
|
If (when started) the water pump has gone would there be no collant being pumped back into the header
Go have a look, coolant should be pumping back into the head via the top thin tube. You should see the coolant running out of it across the top of the tank.
|
D14LY
Member
Registered: 7th Jan 08
Location: North east
User status: Offline
|
the coolant is not being pumped back into the header, so sounds like the water pump,is this a big job?
|
Gareth F
Member
Registered: 16th Jan 08
Location: Location Location
User status: Offline
|
Um yes, about £300 worth depending on damage , get your cambelt changed at the same time. Get it checked out but do not drive it!
|