dalejones
Member
Registered: 9th Dec 08
Location: Swansea, Wales
User status: Offline
|
theres petrol goin through just wont fire, checked all the wiring all seems fine, i know the coilpack and leads r fine as there off my oldd engine, dont kno wot this could be.. any ideas??
|
dalejones
Member
Registered: 9th Dec 08
Location: Swansea, Wales
User status: Offline
|
i did a paperclip test on it and its comeing back 3,1 which is cracks sensor, though iirc it was showin there was a fault with this on my old engine evan after i replaced it
|
EuroCorsaa
Member
Registered: 10th Jul 09
Location: South Wales*
User status: Offline
|
try different ECU mate??!!
|
nad123
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 25th Jun 09
Location: south wales
User status: Offline
|
Crank sensor will come up when engines not running.check earths
|
nad123
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 25th Jun 09
Location: south wales
User status: Offline
|
Also take plugs out and check spark.if u want me 2 come and have a look u2u me
|
dalejones
Member
Registered: 9th Dec 08
Location: Swansea, Wales
User status: Offline
|
rite all earths seem ok, changed the crank sensor still nothin! n e suggestions?
|
Kieran
Premium Member
Registered: 12th Sep 08
Location: Kent
User status: Offline
|
fuse? mine mates c20xe did exactsame i changed the fuse for him and fired up right away
|
dalejones
Member
Registered: 9th Dec 08
Location: Swansea, Wales
User status: Offline
|
hmmm which fuse?
|
Kieran
Premium Member
Registered: 12th Sep 08
Location: Kent
User status: Offline
|
Think it was a red one. But just go though them all
|
dalejones
Member
Registered: 9th Dec 08
Location: Swansea, Wales
User status: Offline
|
checked all the fuses there all fine! I got a feelin the timing is out! im worried as it has kent cams and it has had advanced timing, i think somethin has happened that has knocked the timing out..what could have caused this? and how can i tell?
|
Kieran
Premium Member
Registered: 12th Sep 08
Location: Kent
User status: Offline
|
Only way you will tell is to whip the head off and check for bent valves. Or try timing it to standard and go from there
|
Linch
Member
Registered: 4th May 06
Location: Whickham, Tyne and Wear
User status: Offline
|
Dose it have verniers on it?
|
dalejones
Member
Registered: 9th Dec 08
Location: Swansea, Wales
User status: Offline
|
Yer
|
Linch
Member
Registered: 4th May 06
Location: Whickham, Tyne and Wear
User status: Offline
|
Do you know what degree cams they are?
|