carnagesri
Member
Registered: 8th Jun 02
Location: Ireland - Co.Cork
User status: Offline
|
I have a 1995 3dr corsa with 16 inch alloys et 40 and i was wondering what would be a good lowering height for the car.Could someone also recommend what make of springs to go for.Cheers.
|
Gambit
Member
Registered: 5th Jun 00
Location: Common Sense HQ
User status: Offline
|
40mm allround, and any springs are good apart from Pi
|
Cybermonkey
Member
Registered: 22nd Sep 02
Location: Sydney, Australia
User status: Offline
|
if you are only going for springs, get some bilsteins. I would reccomend getting a full setup though including the shocks 
|
Pete
Member
Registered: 20th Sep 99
Location: Northampton
User status: Offline
|
Bilstein don't make springs....
Chassis Dynamics 90-024 springs are good for an even 40mm drop.
|
Cybermonkey
Member
Registered: 22nd Sep 02
Location: Sydney, Australia
User status: Offline
|
dont i look stoopid now 
|
stuyw
Member
Registered: 15th May 02
Location: North West Drives: Rev3 MR2 Turbo
User status: Offline
|
stay away from PI if u can m8 as they are crap
|
digitalbanana
Member
Registered: 24th Nov 02
User status: Offline
|
What difference do full shocks make over just springs???
can u lower with just springs, and the car wont fuck up??
|
stuyw
Member
Registered: 15th May 02
Location: North West Drives: Rev3 MR2 Turbo
User status: Offline
|
u can lower with just springs and should b ok, but in the long run, ur better off getting a full kit.
|
