t1
Member
Registered: 15th Dec 11
User status: Offline
|
c20let engine done approx 400 miles been told it ran fine, one of the cylinders has this clean straight scratch in the bore, funny thing is it goes all the way to the top, will this cause running problems or is it ok
what may have caused it
run your finger over it and you cant feel it, run your nail over it and you can feel it
[img]http://i1128.photobucket.com/albums/m491/photos12349
|
Dan295
Member
Registered: 9th Oct 06
Location: London
User status: Offline
|
get the block honed and buy some new rings
|
t1
Member
Registered: 15th Dec 11
User status: Offline
|
i presume the whole block would have to be stripped and all the bores honed or just the one bore
whats th consequences of running it as it is if its holding good compression
|
johnhara1
Member
Registered: 19th Oct 06
Location: Newcastle upon Tyne
User status: Offline
|
Take crank and pistons out and take it too an engineers shop.
if you leave it in its current state you're an idiot.
lazy let builds dont last long.
|
t1
Member
Registered: 15th Dec 11
User status: Offline
|
will a hone take this out or will it need a rebore
will i need to buy new pistons
|
johnhara1
Member
Registered: 19th Oct 06
Location: Newcastle upon Tyne
User status: Offline
|
it depends how bad it is, nobody will be able to tell you using a photo mate.
|
Dan295
Member
Registered: 9th Oct 06
Location: London
User status: Offline
|
take it down an reccommended engineering company and show them the damage and the piston that came from that bore
|
