Anty
Premium Member
Registered: 19th Mar 08
Location: droitwich
User status: Offline
|
Is there any How to Guides on how to remove a drivers Front seat.. More door
The drivers side is leaning to one side, i heard a pop noise as i sat down.
|
RCorsa
Member
Registered: 15th Sep 13
Location: West Midlands
User status: Offline
|
Depending on model if it has airbags disconnect battery, unplug pre-tensioners. Unscrew the plastic runner covers, slide seat forward with adjuster, undo bolts, slide it all the way back, undo front bolts. Out it comes, easy enough 
|
corsajay88
Member
Registered: 22nd Aug 11
Location: Upton, Cheshire
User status: Offline
|
Put the little red safety catches in the pretensioner before you do anything. Removing the plastic next to the seat on the door side will give you access to this
|
csifku
Member
Registered: 14th Aug 12
Location: Maidstone
User status: Offline
|
what car ? corsa b or corsa c ? I know about corsa b, put some WD-40 under the car where r the bolts and use torx i think is T30 if im not wrong .... , tka ethe two rear bolts out and lift the seat and slide it forward and its out
|
Jamie-C
Member
Registered: 3rd Jun 08
Location: Ballycastle
User status: Offline
|
Be careful, they snap
|
RCorsa
Member
Registered: 15th Sep 13
Location: West Midlands
User status: Offline
|
quote:
Originally posted by csifku
what car ? corsa b or corsa c ? I know about corsa b, put some WD-40 under the car where r the bolts and use torx i think is T30 if im not wrong .... , tka ethe two rear bolts out and lift the seat and slide it forward and its out
Good point! I presumed it was a C for some reason... Anyway yes, just two bolts on a B, four on a C.
|
csifku
Member
Registered: 14th Aug 12
Location: Maidstone
User status: Offline
|
quote:
Originally posted by RCorsa
quote:
Originally posted by csifku
what car ? corsa b or corsa c ? I know about corsa b, put some WD-40 under the car where r the bolts and use torx i think is T30 if im not wrong .... , tka ethe two rear bolts out and lift the seat and slide it forward and its out
Good point! I presumed it was a C for some reason... Anyway yes, just two bolts on a B, four on a C.
its just hard to asnwer mate when we dont know what car they talk about for :-/
|
Haimsey
Premium Member
Registered: 8th May 05
Location: Nottingham Drives: Corsa B
User status: Offline
|
I found it more hassle but easier and less likely to knacker up the torx bolts by undoing the four that hold the seat to the subframe and then deal with the subframe as a seperate job.
Marcy Marc 
White Sport Progress Thread
|
Ian
Site Administrator
Registered: 28th Aug 99
Location: Liverpool
User status: Offline
|
Just use the biggest drive you can, its T50 ish isn't it?
Half inch drive on a big breaker to start them all, be reet. They're only going to chew if you're straining with not much leverage and it slips.
|
