DODG-E
Member
Registered: 24th Jan 03
Location: Romford, Essex
User status: Offline
|
done an engine conversion (1.2 8v -> 1.4 16v) and i now need to wire in the transponder thingy...
i was told i need to loop the blue/red wires (as there are 2 the same) and wire it into each side of the 9 pin connector..
so one wire would go one side of the plug, and the other wire to the other side of the plug? is that correct?
u need to cut the blue red wire in the plug so one blue and red goes to one end youve cut and the other to the other end so the transponder is looped in the immobiliser if u know what i mean. but i cant remember what blue and red go what end as i think u have to have it the right way round
pls help as this is the last thing i need to do!
thanks...
|