eastend
Member
Registered: 13th Mar 07
Location: Taunton, Somerset
User status: Offline
|
is there anything i can do to check that my engine is properly earthed so i can see if its the reason it isnt starting?
cheers
|
Limecat
Banned
Registered: 25th Jun 05
Location: The Internet
User status: Offline
|
Use jump leads from inlet manifold to the battery negative (or anywhere you suspect you have a crap earth!)
|
eastend
Member
Registered: 13th Mar 07
Location: Taunton, Somerset
User status: Offline
|
how about just a wire lol
|
eastend
Member
Registered: 13th Mar 07
Location: Taunton, Somerset
User status: Offline
|
no joy, connected to lots of points on the engine and still no sprk
|
eastend
Member
Registered: 13th Mar 07
Location: Taunton, Somerset
User status: Offline
|
someone chuck some ideas forward for me to try, still getting no spark from the engine?
the engine is turning and fuel is going through i think as it does smell!
wat can cause no spark? and then i can check?
|
Limecat
Banned
Registered: 25th Jun 05
Location: The Internet
User status: Offline
|
What engine?
|
eastend
Member
Registered: 13th Mar 07
Location: Taunton, Somerset
User status: Offline
|
x16xe
|
Limecat
Banned
Registered: 25th Jun 05
Location: The Internet
User status: Offline
|
When you say you think fuel is going through as you can smell it, it may be that it is in the fuel rail as the pump is providing the pressure but if the injectors aren't pulsing it aint going anywhere. Have you pulled the plugs out to see if they are getting wet? Also bang an LED across the injector to see if it is pulsing.
If you have no feed at the injector and no spark then it will be either crank sensor or ECU. Do you have an EM light on?
Is this a factory setup or some sort of conversion? I assume it has just randomly conked out and has been in there from day 1?
|
eastend
Member
Registered: 13th Mar 07
Location: Taunton, Somerset
User status: Offline
|
no its a conversion from a x14xe, atm i havent got the chip to run the x16xe so trying to run it off of the x14xe ecu just to get it going. it should run!
but just not getting a sprk for some reason, we have looked at the spark plug to see if it is sparking but it doesnt seem to be
ill have to try the led across the injectors!
|
Vaux Lad
Member
Registered: 15th Dec 04
Location: Stoke-on-Trent
User status: Offline
|
Fit the old engines crank sensor, see if its that.
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
when i left my crank sensor off it ran it just popped and banged like fuck
|