jaysc20xe
Member
Registered: 5th Feb 08
Location: cleck/leeds
User status: Offline
|
my corsa idles at 2000rpm all the time. its got an xe engine it. ive replaced the air flow meter, replaced the idle control valve, replaved the lamba sensor and the ecu. nothing at all has worked. its really startin to piss me off now. lol.
dont no if its any relivence but when i florr it the ecu light comes on, but as soon as i turn the ignition off and then bak on it goes off until i floor it again.
please can anyone help me.
[Edited on 02-03-2008 by jaysc20xe]
|
Gezza
Member
Registered: 27th Feb 08
Location: lancashire
User status: Offline
|
do they have a crank sensor???
what about coil packs or dizzy???
|
jaysc20xe
Member
Registered: 5th Feb 08
Location: cleck/leeds
User status: Offline
|
quote:
Originally posted by Gezza
do they have a crank sensor???
what about coil packs or dizzy???
the dizzy cap looks fine. and i was told by j100 that if the crank sensor was broken it wouldnt start. but i'm not 100% on that
|
Sportycorsa86
Member
Registered: 10th Dec 07
Location: hertfordshire ( cheshunt)
User status: Offline
|
Possible air leak ?? maybe your inlet manifold gasket is fooked ?
|
swedge
Member
Registered: 3rd Sep 07
Location: Hawick,scotland drives: 1.4 sri corsa
User status: Offline
|
if the crank sensor is broken it will still sometimes start just not run
my crank sensor was faulty and myt car still started just didnt idle well or drive
|
boz_gsi
Member
Registered: 12th Apr 07
Location: stoke-on-trent
User status: Offline
|
has it always done it?? theres 2 plugs round the back of the engine, red 1 n a black 1 i think, 1 goes to idle control valve and other to another sensor, im quite sure it the red 1 that should go the the idle controle valve. if you have them the rong way round it will make it idle at 2000rpm hope this helps
|
p1723944
Member
Registered: 4th Feb 03
User status: Offline
|
Have you checked to make sure that the throttle cable has the right amount of slack.
That or air leak like Sportycorsa86 said more than likily the inlet.
Spray a load of water round the inlet if it beginds to run funny then you know you have a leak as the inlet will suck the water in.
Good luck
|
jaysc20xe
Member
Registered: 5th Feb 08
Location: cleck/leeds
User status: Offline
|
the 2 clips are on the right way around. i no because i had that problem when i first started it and it jus bounced off the limiter over and over again. the throttle cable has enough slack and is nice and free. not sure if it is the crank sensor because the car drives fine. jus like i say the engine management light comes on when i floor it. havn't checked the inlet gasket yet but will do tonight and let ya no.
anymore suggestions. someone said to me it might be the thottle position sensor. what ya think
cheers for ur help
[Edited on 03-03-2008 by jaysc20xe]
|
