ChrisBoom
Member
Registered: 6th Dec 06
Location: Highland
User status: Offline
|
Right, since Im getting a 1.4 Sport, I need to know its potential.
So, 88bhp iirc? No idea on the tourqe figure though.
Also, what gains are to be expected from a lexmaul, full stainless exhaust and filter?
|
Dave-Creations
Member
Registered: 28th Dec 06
Location: IRELAND
User status: Offline
|
put a 8v flywheel on as opposed to the 16v one, f13c/r gearbox, decat exhaust, and a panel filter should see a nice increase upto about 100 at a rough guess???
|
Richardhhha
Member
Registered: 29th Sep 07
Location: Croydon, Greater London
User status: Offline
|
don't de-cat it unless you want to get taken up the wrongen if cops stop you for a spot check, just put a decent ex manifold on it, preferably a 4.2.1 as you can have the lambda in the right place... Then get a mantzel styled inlet manifold... Lex still have the drawback of the pipe behind the engine causing heat soak, a nice center and rear exhaust, get it re-mapped. And you should be looking at around 100 to 110 figure.. Then get a lightweight flywheel... Mucho fun
|
Simon_16v
Member
Registered: 14th Aug 06
Location: Yorkshire
User status: Offline
|
Was it jr that managed 138bhp?
What spec was that?
|
luke85
Member
Registered: 26th Nov 07
Location: Chesterfield
User status: Offline
|
Inlet manifold and a unichip are the best things to do with this engine IMO then a cat back exhaust and a de-cat if you like. Just have to put the cat back on for the MOT. With a Dbilas inlet, 4 branch manifold, de cat and magnex exhaust with a unichip revving to 7200 you will see 120BHP
|
gavin18787
Premium Member
Registered: 22nd Feb 05
Location: Basildon, Essex
User status: Offline
|
quote: Originally posted by luke85
Inlet manifold and a unichip are the best things to do with this engine IMO then a cat back exhaust and a de-cat if you like. Just have to put the cat back on for the MOT. With a Dbilas inlet, 4 branch manifold, de cat and magnex exhaust with a unichip revving to 7200 you will see 120BHP
Only if its a 1.6 not a 1.4
I would say maybe 110bhp and more sustained torque then before. Jr had cams etc too i think on his to get the power he got
Drives supercharged Tec with torque
|
luke85
Member
Registered: 26th Nov 07
Location: Chesterfield
User status: Offline
|
Thats what I did on my 1.4, will try and dig the dyno sheet out later. Was a few years ago now though. You will not gain torque with the Dbilas manifold though, it shifts power higher up the rev range
|
luke85
Member
Registered: 26th Nov 07
Location: Chesterfield
User status: Offline
|
Found it, 122BHP @ 6400RPM 101lb/ft @ 5700 RPM
Thats before I had the limiter raised to 7200, power was still climbing at the original limiter so had it lifted. Would have made more power but didnt put it on the dyno again, fitted a LET instead
|
luke85
Member
Registered: 26th Nov 07
Location: Chesterfield
User status: Offline
|
If its of interest to anyone heres the sheet, doesnt seem like 3 and a half years ago
|