D14LY
Member
Registered: 7th Jan 08
Location: North east
User status: Offline
|
right just had an c16xe engine put in to my 1.2 8v and having a few problems, engine starts then after about 30 seconds revs start going up and down then will eventually cut out and when i pull away i put my foot down and it just dies then i rev it hard then let clutch out it will go only does it when in low revs and when i put clutch in while driving it will either cut out or revs will go up and down nearly cutting out then eventually will cut out.
any help will be greatly appreciated thanks
[Edited on 17-12-2009 by D14LY]
|
D14LY
Member
Registered: 7th Jan 08
Location: North east
User status: Offline
|
btt
|
Richie
Member
Registered: 3rd Dec 02
Location: Newport, Wales
User status: Offline
|
In my opinion it would either be a vaccum leak or the idle control valve.
|
D14LY
Member
Registered: 7th Jan 08
Location: North east
User status: Offline
|
thanks mate i will try that and get back
|
D14LY
Member
Registered: 7th Jan 08
Location: North east
User status: Offline
|
btt
|
c20letandy1988
Member
Registered: 14th Apr 09
Location: Wirral, Merseyside drives: corsa turbo
User status: Offline
|
idle control valve mate it happend on my 1.4 sport same engine set up
|
Linch
Member
Registered: 4th May 06
Location: Whickham, Tyne and Wear
User status: Offline
|
MAP Sensor?
|
D14LY
Member
Registered: 7th Jan 08
Location: North east
User status: Offline
|
linch its th c16 didnt no they had map sensors do they ?
|
D14LY
Member
Registered: 7th Jan 08
Location: North east
User status: Offline
|
unplugged my lambda sensor and runs alot better only cutting out every now and then goin to get a full standard exhaust and try that
|
Adam-D
Member
Registered: 11th May 02
Location: Cheshire
User status: Offline
|
cts
|
D14LY
Member
Registered: 7th Jan 08
Location: North east
User status: Offline
|
cts braned new just been fitted
|
D14LY
Member
Registered: 7th Jan 08
Location: North east
User status: Offline
|
.
|
johnhara1
Member
Registered: 19th Oct 06
Location: Newcastle upon Tyne
User status: Offline
|
Check wiring to CTS.
|
Richie
Member
Registered: 3rd Dec 02
Location: Newport, Wales
User status: Offline
|
Have you tried the idle control valve yet?!
|