Aidan-Fleming
Member
Registered: 17th May 08
Location: Westhill, Aberdeenshire
User status: Offline
|
Are there two types of knock sensor/ICV loom?
As my bit of loom has a 5 pin plug but no where on my Xe loom for it to plug into?
Found an old pic of my loom with a black single wire coming from it and also the knock sensor with a black wire, looks like those two could go together but then where would the ICV plug connect to?
I the photo you can see the thin black wire in middle of photo also the knock sensor which looks to of been sitting next to it.
[Edited on 23-12-2013 by Aidan-Fleming]
|
Generation
Member
Registered: 7th Jul 09
Location: Essex
User status: Offline
|
Yup, two types
|
Aidan-Fleming
Member
Registered: 17th May 08
Location: Westhill, Aberdeenshire
User status: Offline
|
Differences are?
|
Generation
Member
Registered: 7th Jul 09
Location: Essex
User status: Offline
|
4 or 5 pin.
|
Aidan-Fleming
Member
Registered: 17th May 08
Location: Westhill, Aberdeenshire
User status: Offline
|
You wouldn't happen to have a photo of what the two plugs look like would you?
|
Generation
Member
Registered: 7th Jul 09
Location: Essex
User status: Offline
|
Which two plugs? Te 4 or 5 pin version?
They look identical, but 5 pin it's just slightly wider. Both black
|
Aidan-Fleming
Member
Registered: 17th May 08
Location: Westhill, Aberdeenshire
User status: Offline
|
This is the wire I have coming from here. Brown with white.
On my knock sensor I have two wires, what do I do?
|