X 60RSA
Member
Registered: 20th Aug 01
Location: Lincoln
User status: Offline
|
My C20XE is really noisy when the oil is cold, just top end, i think i need new tappets, just wondering if anyone else has had this problem........its when the oil is cold and alot thicker.....doesn't seem to get to all the right areas, once its had a little run, well say 5-10mins its as quiet as a mouse!
I'll probably have them done anyway, just curious as to whether it is a common problem?
|
Rileysport
Member
Registered: 18th Jun 04
Location: West Yorkshire
User status: Offline
|
if tappets are boogered oil drains outa them ehen u turn off, so they need to refil when u restart hence the noise
|
X 60RSA
Member
Registered: 20th Aug 01
Location: Lincoln
User status: Offline
|
Cheers mate, thought as much! Need some new stem seals as well, the little baby is smoking in first and second on full throttle, i know its not the rings as its had a compression test so we are ok there! Its using a litre every 300miles, but thats giving it some over that 300!
|
Rileysport
Member
Registered: 18th Jun 04
Location: West Yorkshire
User status: Offline
|
yeah my 1.4's lovvin oil too
|
X 60RSA
Member
Registered: 20th Aug 01
Location: Lincoln
User status: Offline
|
I was told to obvisously keep ontop if it, and it will be ok until i have it done......think i'll have the head gasket done at the same time.
Know of any good Vauxhall sites for spares.....top end wise, head etc.....?
|
Rileysport
Member
Registered: 18th Jun 04
Location: West Yorkshire
User status: Offline
|
usually get genuine vaux top end wise... otherwise try autovaux.co.uk
|
X 60RSA
Member
Registered: 20th Aug 01
Location: Lincoln
User status: Offline
|
Cheers mucka!
|
Rileysport
Member
Registered: 18th Jun 04
Location: West Yorkshire
User status: Offline
|
no probs... sum1 will say i'm wrong and suggest summat else
|
and-m
Member
Registered: 5th May 02
Location: Liverpool. Drives. Skud vRS.
User status: Offline
|
You can clean the crap outta the tappets, worth doing otherwise itll cost you close to 200 for new ones + cambelt etc etc
Mine are quiet from start, a second or two and thats it.
|
Fad
Member
Registered: 1st Feb 01
Location: Dartford Kent Drives: 330cd
User status: Offline
|
autovaux lifters are mate in the same factory as GM ones so save yourself a few quid and get them,.
If you are on a budget just take the lifters out and soak them in degreaser or carb cleaner to clean them.
Over time oil blocks the litlle pin holes so it takes longer till the oils warm for the tappets to fully fill.
|
X 60RSA
Member
Registered: 20th Aug 01
Location: Lincoln
User status: Offline
|
A bloke informed me yesterday that my C20XE engine does not like to have engine flush put through them, doesn't do them alot of good, whether its true or not i'm not sure.....
|
LukeGSi
Member
Registered: 9th Dec 03
User status: Offline
|
Engine flush can remove small carbon deposits that block potential oil leaks. I always use it personally
|
X 60RSA
Member
Registered: 20th Aug 01
Location: Lincoln
User status: Offline
|
Ah! Well he said they dont act very well to it, find it hard to believe but i'm no real expert..........
|
myke
Member
Registered: 7th Feb 01
Location: High Wycombe, Buckinghamshire
User status: Offline
|
i had my lifetr ultrasonically cleaned.
they weren't noisy, but were c oming out while the head was being flowed, so had them done anyway.
should save you some cash on buying new ones.
|
