seanreay1986
Member
Registered: 30th Jul 04
Location: Washington, Tyne and Wear
User status: Offline
|
Just had my 1.0 12v converted to a 1.4 16v and car keeps stalling at junctions etc. Been told i need to join a wire from the red/blue wire in the gearbox speed sensor to the red/blue wire in the ecu but everytime i do this i just get the immobiliser light flashing. As soon as i disconnect the wire the immobiliser light doesnt flash.
Please help
|
Rileysport
Member
Registered: 18th Jun 04
Location: West Yorkshire
User status: Offline
|
Any fault code (ecu light on) ?
|
seanreay1986
Member
Registered: 30th Jul 04
Location: Washington, Tyne and Wear
User status: Offline
|
apparantly fault code 24, no speed sensor, lad i got the engine off said he had to piggy back the wire that goes from the gear box to the dash to the red/blue wire in the ecu but as soon as i do that the immobiliser kicks in
|
Rileysport
Member
Registered: 18th Jun 04
Location: West Yorkshire
User status: Offline
|
Sounds weird mate, the wire should already run from ecu to dash clocks
|
seanreay1986
Member
Registered: 30th Jul 04
Location: Washington, Tyne and Wear
User status: Offline
|
with the engine originally being cable driven clocks it doesnt have the wire going from the dash to the ecu
|
Rileysport
Member
Registered: 18th Jun 04
Location: West Yorkshire
User status: Offline
|
Mines cable driven.. still has a red/blue wire into the clocks 
|
seanreay1986
Member
Registered: 30th Jul 04
Location: Washington, Tyne and Wear
User status: Offline
|
mine has a red/blue wire connected to the clocks, red/blue wire connected to the gearbox and a red/blue wire going into the ecu but apparantly with my clocks being electronic i need to join a wire to the re/blue wire in the ecu to tell the ecu that the car is actually doing some speed, otherwise it will just cut out
[Edited on 08-06-2005 by seanreay1986]
|
