Rob B
Member
Registered: 8th Jan 04
Location: Area Motorsport Drives: Race EP3
User status: Offline
|
Im going to take mine off and give it a good clean and fit a blanking plate in the process ive read every post when i did a search for it and im a bit confused... some say you just screw in a piece of metal over where the egr valve went and leave the egr valve loose, others say you just take it out and clean it, others say you cut something out a coke can sandwhich it between the inlet and the EGR valve,... which is correct ?
found this pic which out of the three is the one i need to make up
[Edited on 06-12-2005 by Rob B]
[Edited on 06-12-2005 by Rob B]
|
bubble
Member
Registered: 24th Jan 04
Location: Darwin, NT Australia.
User status: Offline
|
i just linked 2 wires on the plug to the valve-job was a good un!
its the wires on each end of the plug
|
Rob B
Member
Registered: 8th Jan 04
Location: Area Motorsport Drives: Race EP3
User status: Offline
|
right WTF  What do you mean 2 wires you mean from the 4/5 pin plug linked them to what ? In the 20 + posts i have just read i havent read that 
|
Stu_22
Member
Registered: 25th Mar 02
Location: Luton
User status: Offline
|
Thats the plates I made up they all need to be used so that the valve can still function normally.
So take the valve off clean it and put it back with the plates in front of the valve
|
Rob B
Member
Registered: 8th Jan 04
Location: Area Motorsport Drives: Race EP3
User status: Offline
|
so i need to use all three pictured above ? which order do i put them on in ?
|
broster
Premium Member
Registered: 6th Dec 02
Location: Drives: E39
User status: Offline
|
plate with two holes net to the valve then the plate with one hole then the plate with no hole up on the inlet.
|
Rob B
Member
Registered: 8th Jan 04
Location: Area Motorsport Drives: Race EP3
User status: Offline
|
right ok i sort of understand now, going to try and sort this out sometime this week.
|
VegasPhil
Premium Member
Registered: 16th Jan 05
Location: Fareham, Hants Drives: Octavia VRS
User status: Offline
|
Check the links at the bottom of this Thread Rob Part numbers on the Top one.
Corsa 2.0 16v Vegas - Sold
|
Rob B
Member
Registered: 8th Jan 04
Location: Area Motorsport Drives: Race EP3
User status: Offline
|
47802374 ?
|
MJ
Member
Registered: 18th Sep 03
Location: Hampshire Drives: ITR DC2 + Skoda Felicia
User status: Offline
|
so u need all 3
|
Rob B
Member
Registered: 8th Jan 04
Location: Area Motorsport Drives: Race EP3
User status: Offline
|
Yes Mark it seems so its been explained to me in a bit more detail but basically you have to use all three in the way Broster has explained so the valve can still move slightly.
|
