Forbes789
Member
Registered: 19th Sep 07
Location: Buckie, Moray
User status: Offline
|
just bought air horns, 3 trumpets on they wire through the original horn, the diagram i have has a on/off/on switch and allows the old horn and the air horns to be used (one on each on conection). anyone know where the wire from the horn goes to in the engine bay, or where the speaker tha makes the noise is so i can cut into it. or is it easer to do it behind the wheel??.
by the way its air horns not that stupid ass musical ones
anyone got any ideas where to start?
|
Forbes789
Member
Registered: 19th Sep 07
Location: Buckie, Moray
User status: Offline
|
anyone??
|
Ellis
Member
Registered: 11th Sep 07
Location: Aberdeenshire
User status: Offline
|
Horn is mounted behind the bumper, cut it there and join, easier i thought than making a new circuit from behind the wheel
|
Forbes789
Member
Registered: 19th Sep 07
Location: Buckie, Moray
User status: Offline
|
ok i decided against using the existing horn lol
i wired a switch into where my front fogs switch used too be (aint got no front fogs anymore!) and ran a wire from the battery to a inline fuse to the switch then the other terminal on the switch to the compresers + then a cable from the compressors - to an earth, flicked the switch and bam theres noise lol
i put a 15 amp fuse in, would this be big enough or do you think a smaller one to be on the safe side????
i wouldnt say they look good cause in fact they dont i'll post pics later, but i got a metal plate bolted it to the car the bolted the 3 horns to this and the compressor to the car, wired up all flexi cables for the air and tidy'd all the cables.
job done lol
|
