Rich_M
Member
Registered: 10th Dec 06
Location: Cumbria
User status: Offline
|
Anything to watch out for ??
Take it its pretty staright forward, no need to remove any engine mounts or owt daft ??
Cheers
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
piece of cake to do really just make sure the marks are lined up properly nothing major has to come off. bottom pulley is a bit of a pig to get off
|
Rich_M
Member
Registered: 10th Dec 06
Location: Cumbria
User status: Offline
|
Bottom pulley just fiddly to get at or just tight ?? is it just held on with one big bolt or a few little ones ??
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
one big bolt. torx socket. put it in gear and take the strain on it and give the rachet a good twat with a hammer to shock it off
|
Rich_M
Member
Registered: 10th Dec 06
Location: Cumbria
User status: Offline
|
Cool, don't suppose you know what size Torx bit its do you ?
Are the rollers / tensioners usually ok or they need changing ? just changing it before i sell it so don't wanna spend money if not needed.
|
marklawton
Member
Registered: 24th Apr 05
Location: Pensby, Wirral Drives:Golf mk4 GTI
User status: Offline
|
its not much extra for the rollers so i would get them aswell
|
Rich_M
Member
Registered: 10th Dec 06
Location: Cumbria
User status: Offline
|
Ideas on rough cost of rollers / tensioners ??
|
marklawton
Member
Registered: 24th Apr 05
Location: Pensby, Wirral Drives:Golf mk4 GTI
User status: Offline
|
whole kit is about £80
|
Robin
Premium Member
Registered: 7th Jan 04
Location: Northants Drives: Clio 182 Cup
User status: Offline
|
I wouldn't even consider doing the belt swap without doing the rollers.
|
Richardhhha
Member
Registered: 29th Sep 07
Location: Croydon, Greater London
User status: Offline
|
quote: Originally posted by marklawton
whole kit is about £80
got a cam belt kit from vauxhall the other month as i needed it due to replacing oil pump gasket...... kinda blew it to pieces when doing 120 for to long wont be doing that again... anyhooo it cost me £122 for belt, tensioner and 2 rollers........ bit expensive for small pieces of plastic really
|
Richardhhha
Member
Registered: 29th Sep 07
Location: Croydon, Greater London
User status: Offline
|
torx bit is a E18, and just get someone to sit in the car with there foot on the break HARD and it will come undone easy....
|