Simon_16v
Member
Registered: 14th Aug 06
Location: Yorkshire
User status: Offline
|
Hey,
I have an inlet manifold that i bought off danh785.
It only has one vacuum attachment, can i use t-pieces to attach them all to the brake servo? As in the MAP and FPR vacuum's?
Also would the standard throttle cable bracket fit onto the manifold?
Is there any additional parts i should buy? I have already bought the throttle body gasket and the inlet gasket.
Thanks for your help
|
Steve X16XE
Member
Registered: 31st Dec 06
Location: Barnsley, South Yorkshire
User status: Offline
|
Yeah you can use a T peice. I have done with mine and had no problems.
I think that you have all the bits. Post up a pic so we can check for you.
|
Simon_16v
Member
Registered: 14th Aug 06
Location: Yorkshire
User status: Offline
|
It's my avatar as firefox aint playing ball lol the gaskets are not shown there but i bought them yesterday
|
Steve X16XE
Member
Registered: 31st Dec 06
Location: Barnsley, South Yorkshire
User status: Offline
|
Couple of pics for you here.... You may need to find somewhere that can make this for you.... see where there are 2 extra little pipes coming out of that 1 fat one?
http://www.corsasport.co.uk/carimages/4815/mantzle_2.jpg
Plus you'll need to buy a bracket that'll hold your cable. It's like an L piece with a big hole in it. I can't find any pics of it just yet.
|
Simon_16v
Member
Registered: 14th Aug 06
Location: Yorkshire
User status: Offline
|
Can i not use the standard one? Modify it?
Will i not be able to get some t-pieces and just fit them into the brake servo hose?
|
Steve X16XE
Member
Registered: 31st Dec 06
Location: Barnsley, South Yorkshire
User status: Offline
|
Maybe. As it's the brakes, i'd make sure that everything is ok with that hose. The other hoses and smaller so you'd need a reducer.
|
Steve X16XE
Member
Registered: 31st Dec 06
Location: Barnsley, South Yorkshire
User status: Offline
|
This is that cable holder i was telling you about....
The link higher up the page... if you look at that you'll see 2 bolts that are sticking out. You'll need one of these to hold your accelerator cable.
|
Simon_16v
Member
Registered: 14th Aug 06
Location: Yorkshire
User status: Offline
|
Cheers Steve, is there any chance i could have you number in case i get stuck doing it?
Thanks for your help
|
Steve X16XE
Member
Registered: 31st Dec 06
Location: Barnsley, South Yorkshire
User status: Offline
|
It's in here. That's why i couldn't find it.
|
Simon_16v
Member
Registered: 14th Aug 06
Location: Yorkshire
User status: Offline
|
|