dean101287
Member
Registered: 22nd Jul 07
Location: Cardiff
User status: Offline
|
Rite, got the head back off my 106 1.4 diesel.
The top of the block is covered in water so how do I go about getting it out? Its everywhere, in the bolts holes ect..
Obviously need to get it out because the bolts wont tighten otherwise. Any ideas?
|
wozza51
Member
Registered: 9th Apr 08
Location: Croydon
User status: Offline
|
air blower
or WD-40
possibly acid dip the head
|
dean101287
Member
Registered: 22nd Jul 07
Location: Cardiff
User status: Offline
|
Its not the head its the holes in the block
|
wozza51
Member
Registered: 9th Apr 08
Location: Croydon
User status: Offline
|
air blower then mate
|
barneykarl
Member
Registered: 29th Jul 06
Location: Stevenage
User status: Offline
|
Tampax  or blower, air line.
|
andyc1234
Member
Registered: 7th Nov 06
Location: Lancashire
User status: Offline
|
staw and suck it out?
|
dean101287
Member
Registered: 22nd Jul 07
Location: Cardiff
User status: Offline
|
Done it now. Syringe and a straw on the end. Just need to clean up the mating faces, check the head aint warped woth a steel ruler and start to put it back together. Hope it runs properly once done.
|
cheater
Member
Registered: 14th Dec 08
Location: Southampton
User status: Offline
|
Get an air gun and blow it out but watch out as it goes everywhere!
Did this on mine, but your right mate the water can cause hydrolic build up and crack the block.
|
