Chris_Sport
Member
Registered: 6th Jan 05
Location: Barrow In Furness
User status: Offline
|
As above, is it an easy job to change?
I have access to ramps if it needs to be accessed from underneath.
Thanks.
|
Mike
Organiser: North West and North Wales Premium Member
Registered: 20th May 06
Location: nr. Skipton, North Yorkshire
User status: Offline
|
Yes, it's accessed from underneath and it's 1 plug and 1 bolt. I do seem to remember a slight issue when I changed mine, possibly lack of space I'm not sure but 10 minutes and it was job done so it definitely wasn't a major issue.
|
Chris_Sport
Member
Registered: 6th Jan 05
Location: Barrow In Furness
User status: Offline
|
Thanks again Mike.
You're like my personal helper with this issue!
Don't suppose you managed to find the pic of where it is did you?
|
Mike
Organiser: North West and North Wales Premium Member
Registered: 20th May 06
Location: nr. Skipton, North Yorkshire
User status: Offline
|
Just found it now, it was older than i thought so I didn't go back far enough last night. It's not a great pic but it shows where it is compared with the inner CV joint and starter motor

I'm so helpful on the subject because i changed mine twice and it was never the problem so it sticks with me It was different problems that I was having though, not cutting out.
[Edited on 25-04-2011 by Mike B]
|
Chris_Sport
Member
Registered: 6th Jan 05
Location: Barrow In Furness
User status: Offline
|
Ha, thanks,
Guessing the pic is on its side? So the starter motor is above it?
|
Mike
Organiser: North West and North Wales Premium Member
Registered: 20th May 06
Location: nr. Skipton, North Yorkshire
User status: Offline
|
Yeah, camera space was limited
|
Chris_Sport
Member
Registered: 6th Jan 05
Location: Barrow In Furness
User status: Offline
|
Brill.
Thanks again for all your help.
|
Mike
Organiser: North West and North Wales Premium Member
Registered: 20th May 06
Location: nr. Skipton, North Yorkshire
User status: Offline
|
No problem pal.
|
Chris_Sport
Member
Registered: 6th Jan 05
Location: Barrow In Furness
User status: Offline
|
Quick update on this - sensor replaced and all is well.
The sensor is held in by a female torx. I think it is size 10. Unfortunately I didn't have one of these so managed with a size 10 spanner as it wasn't in tight.
Total job took about 15 minutes.
|