-Aliba-
Member
Registered: 15th Apr 02
Location: Ayrshire
User status: Offline
|
So folks i aint got a clue what to do here....
As far as i can see, my "diagnostic plug" is a 16 pin piece, although only 5 pins are being used.
Also cant see any LED or whatever to show the flash.
So, can anyone shed some light on what i'm doing here???
|
Neshol
Member
Registered: 10th Jul 02
Location: Midlands
User status: Offline
|
http://www.topbuzz1.carenthusiasts.co.uk/info/fault_codes/fault_codes.htm
|
-Aliba-
Member
Registered: 15th Apr 02
Location: Ayrshire
User status: Offline
|
i know, i've checked through it, but it says to connect pins 5 and 6, but they dont both have contacts in my plug if u catch my drift.
|
CRB 553
Member
Registered: 5th Apr 02
Location: NE Drives: Punto GT
User status: Offline
|
i had the same problem with my 1.0, on ma new engine the ecu is separate but on the 1.0 its on the side of the engine. U can earth a wire from the actual ecu but its a sealed connector so wudnt advise ripping it too pieces, just go to a garage and get it done
[Edited on 04-09-2003 by CRB 553]
|