alan-g-w
Member
Registered: 9th Nov 07
Location: Glasgow
User status: Offline
|
As above, what's everyone done to fit the air temp sensor (one before the AFM)? Mine's just been stuck into a bit of 70mm iirc rubber hosing that's had a circle cut in it - not too good a seal around it. I've put a fine bead of silicon around it but I think it's making it run shite with it 'leaking'.
Pictures would be great as well.
|
Sean-B
Member
Registered: 1st May 07
Location: Wolverhampton Drives: 200SX S14a
User status: Offline
|
Have you got a dizzy or coil type XE?
My coil type doesn't have an ATS
|
DaveB
Member
Registered: 29th Dec 00
Location: Huddersfield
User status: Offline
|
Coil pack XE should have an inlet temp sensor, it goes just BEFORE the AFM. The standard pipe can still be bought from Autovaux if you really need it.
Dizzy xe does NOT have one.
To check the seal, spray carb cleaner around it; if the revs 'rise' then you know its leaking.
|
alan-g-w
Member
Registered: 9th Nov 07
Location: Glasgow
User status: Offline
|
Coil type as well over here as well, that's odd.
Anyone able to shed some light? I'm not too clued up on sensors and the like.
|
alan-g-w
Member
Registered: 9th Nov 07
Location: Glasgow
User status: Offline
|
Sound DaveB, whats the standard pipe like though? The bit of hosing that the sensor's in is only about 3 inches long.
|
DaveB
Member
Registered: 29th Dec 00
Location: Huddersfield
User status: Offline
|
just had a quick look for pictures but can't find any.
Its basically like a normal air pipe, with a big nipple thing bulging out of it; the Air temp sensor sticks in this nipple thing lol
|
alan-g-w
Member
Registered: 9th Nov 07
Location: Glasgow
User status: Offline
|
Aye I know what you're on about, like a plastic/ rubber boss. I've got a bit of room on the left hand side where I could fit a longer hose I'll see about that, cheers mate.
Anyone else got this setup and have a picture of it?
[Edited on 09-12-2009 by alan-g-w]
|
