richy_p2009
Member
Registered: 22nd Dec 09
Location: Ryhope, Tyne and Wear
User status: Offline
|
is it easy or a pain in the arse to get the full in let manifold off my 1.4 16v sport engine as i dropped a plactic nut down the bottom half when i had the top part off. cheers in advance
|
scottyp1989
Member
Registered: 29th Jul 07
Location: Warley, West Midlands
User status: Offline
|
a pain TBH and if you have drioped it down the bottom inlet theres a chance its in your engine now
|
richy_p2009
Member
Registered: 22nd Dec 09
Location: Ryhope, Tyne and Wear
User status: Offline
|
it keeps jamming the valve. do you reckon i could suck it out if i get powerful hoover or summit like that
|
scottyp1989
Member
Registered: 29th Jul 07
Location: Warley, West Midlands
User status: Offline
|
not sure, depends where it is in the head and if its done any damage. i would personally take the head off and inspect valves etc if its making them stick
|
johnhara1
Member
Registered: 19th Oct 06
Location: Newcastle upon Tyne
User status: Offline
|
I doubt even your mams dyson is gna suck the nut out of the inlet.
Head off....
|
scottyp1989
Member
Registered: 29th Jul 07
Location: Warley, West Midlands
User status: Offline
|
and if its a plastic nut and you have been running the engine it has probably melted everywhere, so might be an even bigger job
|
johnhara1
Member
Registered: 19th Oct 06
Location: Newcastle upon Tyne
User status: Offline
|
quote: Originally posted by richy_p2009
it keeps jamming the valve. do you reckon i could suck it out if i get powerful hoover or summit like that
I hope that's when you turn it by hand
Platic nut could still bend a valve.
|