Matt H
Member
Registered: 11th Sep 01
Location: South Yorkshire
User status: Offline
|
Big/hard job on a C20XE Corsa?
Not a happy chappy as I currently only have the one car & if that goes Im fooked for getting to work 
|
AdamF
Premium Member
Registered: 24th Apr 02
Location: Bexhill, East Sussex
User status: Offline
|
should be straight forward. f20??
if it is then it will have the plate on the bottom to drop the clutch without taking the box off.
you may have to undo the gearbox mount so you can get the end plate off to access the input shaft
|
BeArDy
Member
Registered: 7th Aug 00
Location: Manchester
User status: Offline
|
easy job mate
30mins at the most
(if you get the gearbox spline slide hammer about £20)
- jack car up and put on axle stands
- take cover off bottom of box
- take side plate of side or gearbox
- screw in slide hammer onto spline shaft and pop shaft out.
- unbolt clutch presure plate
- clutch is out
any probs give us a call mate and will help you out over the phone
[Edited on 03-01-2006 by BeArDy]
|
AdamF
Premium Member
Registered: 24th Apr 02
Location: Bexhill, East Sussex
User status: Offline
|
- jack car up and put on axle stands
- take cover off bottom of box
- get some on in the car to push the pedal to the floor while you put retaining clips to hold the pressure plate and clutch plate together.
- take side plate of side or gearbox
- screw in slide hammer onto spline shaft and pop shaft out.
- unbolt clutch presure plate
- clutch is out
added one mate
also there may be a circlip and a screw holding the input shaft in. if the last person in there put it back in. 
[Edited on 03-01-2006 by AdamF]
|
Matt H
Member
Registered: 11th Sep 01
Location: South Yorkshire
User status: Offline
|
Appreciated guys
|
Matt H
Member
Registered: 11th Sep 01
Location: South Yorkshire
User status: Offline
|
Any one recommend a good clutch to go for?
|
Matt H
Member
Registered: 11th Sep 01
Location: South Yorkshire
User status: Offline
|
TTT
|
