gsimark
Member
Registered: 14th Dec 05
User status: Offline
|
here's one for you lot to get stuck into, i have a gsi (c16xe) engine, on saturday i'm getting another head of leeklad, i want to re-build it with a fast cam kit, but also put bigger vales in it which involves grinding out the seat angles,
question is : who can do it for me including supply the cam kit, valves basiclly do the whole job
|
eskiboy
Member
Registered: 12th Nov 04
User status: Offline
|
where are you???
|
gsimark
Member
Registered: 14th Dec 05
User status: Offline
|
midlands
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
wont need bigger valves, no gain at all unless you are looking at building a 250bhp + 1.6
which I think you are probably not doing. c16xe standard head is good enough to flow 160+ bhp before any real restriction.
|
Warren G
Member
Registered: 14th May 06
Location: Kent
User status: Offline
|
just remove the ruff casting marks, and port out the ports to the size for the gaskets (about 1mm you can do)
leave the valves, good standard
|
gsimark
Member
Registered: 14th Dec 05
User status: Offline
|
so your say that i get a pair of cams and have the polished and ported gas flowed
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
what else are you doing to the engine? cams and modified head are a waste of time unless you are planning new inlet, vernier pulleys, mapping, exhaust, manifold etc....
|
gsimark
Member
Registered: 14th Dec 05
User status: Offline
|
yeah all that in good time trying to source an inlet now a lad on mig builds replica's of mantzl, a janspeed manifold for my b'day in feb and the pully will be fitted with the cam kit then finally a re-map, what you think do it in that order
|
L30 SCT
Member
Registered: 27th Nov 05
Location: aberdeen
User status: Offline
|
i could of sold you my head but its gone now.
i still have a pro-tech manifold if your wanting
|
gsimark
Member
Registered: 14th Dec 05
User status: Offline
|
how much??
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
the migweb replica inlets are shit, ask escortgti his fell apart
cant fit cam pulleys without aftermarket management either (unless you get dbilas ones) but you will also need a remap to get it all running well
|
L30 SCT
Member
Registered: 27th Nov 05
Location: aberdeen
User status: Offline
|
£120
|
