TomWilly
Member
Registered: 20th Sep 05
Location: Bristol
User status: Offline
|
I have the GM EGR valve blank,
Its quite thick so i was wondering, for anyone who has used this, did you take EGR valve off completely? if so do you have to tell the ECU or something?
Thanks, Tom
|
Dean_W
Member
Registered: 13th Dec 05
Location: Downham Market, Norfolk
User status: Offline
|
Use longer bolts and attach it back onto the inlet. Leave it plugged in or the eml light stays on.
|
Warren G
Member
Registered: 14th May 06
Location: Kent
User status: Offline
|
if your still going to bolt the egr back on, just cut a bit of tin and make your own blanking plate!
|
Vaux Lad
Member
Registered: 15th Dec 04
Location: Stoke-on-Trent
User status: Offline
|
Fit the plate with the egr, and bolt the lot on.
|
Warren G
Member
Registered: 14th May 06
Location: Kent
User status: Offline
|
of just get the thin blanking plate gasket!
|
TomWilly
Member
Registered: 20th Sep 05
Location: Bristol
User status: Offline
|
How hard is it to get to?
Easier from above or below?
|
Vaux Lad
Member
Registered: 15th Dec 04
Location: Stoke-on-Trent
User status: Offline
|
Which engine?
8v, easy.
16v, not so easy
|
TomWilly
Member
Registered: 20th Sep 05
Location: Bristol
User status: Offline
|
haha X16XE
|
Vaux Lad
Member
Registered: 15th Dec 04
Location: Stoke-on-Trent
User status: Offline
|
Its on the back of the lower inlet, probably need remove the tb etc to get to it.
|