ChrisBoom
Member
Registered: 6th Dec 06
Location: Highland
User status: Offline
|
The one on the inlet, I broke mine taking it off, so now just the smooth part at the bottom is left, how on earth will I get it out? joey736 very kindly sent me a new one, just need to get the old one out
Also, anyone know hot to get the clips that hold the fuel hoses onto the tb back on? Weird buggers o things
|
Vaux Lad
Member
Registered: 15th Dec 04
Location: Stoke-on-Trent
User status: Offline
|
The clips you have to clamp to make the "clip" end go over the other bit.
If you get me,lol.
I just replaced them for proper fuel hose jubilee clips, much easier.
As for the temp sender, maybe drill through it with a thinner drill bit than the hole, and then see if you knock the rest of the sensor through the hole
|
ChrisBoom
Member
Registered: 6th Dec 06
Location: Highland
User status: Offline
|
Jubilee clips it is
Its threaded though, would need to get it out without damaging the thread for the new one
|
Vaux Lad
Member
Registered: 15th Dec 04
Location: Stoke-on-Trent
User status: Offline
|
Make sure its a proper fuel hose clip, because normal ones tend to dig into the hose and it can split after a while.
CAn you not get a small set of pliers on the end of the sensor, inside the inlet?
|
ChrisBoom
Member
Registered: 6th Dec 06
Location: Highland
User status: Offline
|
That would mean taking off the inlet
Ill figure something out, nearly got it with a big torx bit, but it slipped.
|
Vaux Lad
Member
Registered: 15th Dec 04
Location: Stoke-on-Trent
User status: Offline
|
Oh right, i didn't know the inlet was fitted
Be prepared for coolant spillage if the coolants been refill too.
|
ChrisBoom
Member
Registered: 6th Dec 06
Location: Highland
User status: Offline
|
quote: Originally posted by Vaux Lad
Oh right, i didn't know the inlet was fitted
Be prepared for coolant spillage if the coolants been refill too.
Oh dear
Had it off already, nothing seemed to come out. Just when putting it back on, I broke it
|