Warren G
Member
Registered: 14th May 06
Location: Kent
User status: Offline
|
should run on standard pistons??
duration: 262°
peak timing: 110°
valve lift: 10,0
lift at TDC: IN = 1,3 / EX = 0,6
valve clearence: hydro
with dbilas pulleys - so have timing marks like normal
locks up when turning over, have tryed with crank 360 degrees aswell
|
RCS
Member
Registered: 26th Jan 05
Location: Lichfield/Dundee
User status: Offline
|
Does the cam rotate freely in the cylinder head on its own?
|
Warren G
Member
Registered: 14th May 06
Location: Kent
User status: Offline
|
no
its hitting the cylinder head
im off with the file now
|
RCS
Member
Registered: 26th Jan 05
Location: Lichfield/Dundee
User status: Offline
|
Problem solved
|
Scotty C
Member
Registered: 6th Nov 05
Location: Kidderminster Drives: 1.6 16v Sport
User status: Offline
|
264 is the max with standard pistons, so I don't see why 262 wont work.
|
Dave A
USER UNDER INVESTIGATION - DO NOT TRADE
Registered: 10th Dec 03
Location: County Durham
User status: Offline
|
quote: Originally posted by Monster
264 is the max with standard pistons, so I don't see why 262 wont work.
288 will go with standard pistons as well. clearance is minimal and timing needs to be a few deg from optimum but they will go in and run well.
its also down to the lift, I did some 292 degree cams with very little lift recently for a customer with standard pistons.
|
Vaux Lad
Member
Registered: 15th Dec 04
Location: Stoke-on-Trent
User status: Offline
|
Sorted it now Warren?
Aye, the cam lobe will have been hitting the head casting Good job you turned it over by hand first
|
Warren G
Member
Registered: 14th May 06
Location: Kent
User status: Offline
|
casting marks hitting
excuse the poor pics
after dremeled it away
problem solved
|